Architect and Engineer’s Specifications: NV-32-H Network Video Endpoint (Core Capable) When operated as a video encoder or decoder, the network video endpoint shall be a component in a distribution system that routes 4K60 4:4:4 video over a Gigabit Ethernet network. It shall use Q-SYS Shift data compression to ensure highest quality with very low latency. The endpoint shall have three HDMI 2.0 Inputs and two HDMI 2.0 outputs and shall be fully compliant with HDCP 1.4 and 2.2.t shall also support AV Bridging with Q-SYS Cameras. It shall also have an RJ-45 network port with Power over Ethernet (802.3bt Type 4) compatibility. The network video endpoint shall natively route audio data through a QSC Q-SYS network without needing to use AES67 or the Q-SYS Media Stream Receiver. Its sound card-level stereo analog audio inputs and outputs shall be on 3.5 mm TRS connectors. It shall function as a video transmitter or as a receiver, depending on the configuration by the user. When the device is placed in Core Mode, the device shall support Q-SYS audio and control processing. A single VoIP softphone will be supported by this product in Core Mode. The HDMI I/O may be used to support local video switching and scaling. Additionally in Core Mode, AV bridging of Q-SYS Cameras as well as bidirectional system audio to and from USB is also supported. The product shall be mountable in a standard AV rack or on a surface. It shall be a half rack space wide and one rack unit (1.75 inch) tall, allowing it to be mounted beside other half-rack equipment such as the Q-SYS I/O-8 Flex and QSC SPA Series power amplifiers.The product shall be powered by a 48-volt DC external power supply or through the network port using Power over Ethernet (802.3bt Type 4).The product shall be the QSC Q-SYS NV-32-H(Core Capable).