DCP 100
Digital Cinema Processor
Features
- Digital inputs for up to eight channels of audio
- Network control and monitoring via SNMP
- Serial automation control via RS-232
- Analog Inputs for film processors, non-sync and Mic/line
- Master volume and full 1/3 octave graphic EQ on all channels
- Booth monitor with touch screen control for easy operation
- Digital loudspeaker crossovers - three passive or bi-amp screen channels
- Compatible with all existing DCA amplifiers - thousands of DCA equipped screens are ready for full network monitoring and control
- Replaces the DCM-1, DCM-10 and DCM-10D for digital projection retrofits
- Dual power supplies with load sharing for seamless operation in the event of failure
- SD memory card for quick unit swap - restores all settings
- Multiple bypass modes routes audio around failed components to insure that the show will go on
- DCP Manager and DCPNet PC-based application for set-up, control and monitoring
- DCP Connect mobile app for iPhone and Android provide control and monitoring capabilities via smart phone
- DSP presets for DCS speakers for great "out of box" performance and reduced set-up time
- Crossovers support three passive and active 2-way systems
- Easily integrates with existing film processors for dual film/digital projection systems
- Continued development of software and firmware will add new capabilities to the existing hardware with easy firmware updates
- The DCP 100 is designed expressly for the needs of D-Cinema sound systems
SPECIFICATIONS | DCP 100 Digital Cinema Processor |
Front Panel Controls | |
Power switch | Rocker switch |
Mute control | Push button |
Auditorium fader | Rotary encoder |
Monitor volume/parameter adjust | Rotary encoder |
Menu-driven LCD | Touch control LCD |
Rear Panel Connectors | |
D-Cinema input | DB-25: AES3/EBU channels 1-8 |
Audio Formats | 5.1, 5.1 EX, 7.1 DS |
Analog input | DB-25: Analog audio channels 1-8 |
Universal Mic/Line input | XLR: Mic (+ phantom pwr) or line level |
S/PDIF input | RCA: Stereo digital audio interface and Lt/Rt Matrix |
RCA (L/R) inputs | RCA (two): Stereo Left and Right and Lt/Rt Matrix |
Dataport outputs | HD-15 (eight): QSC amplifier interface |
Automation inputs | 2 x 6-pin Euro-style (six) digitally-sampled analog control inputs |
Serial Control | DB-9 RS-232 serial interface |
Logic output | 4-pin Euro-style (two) outbound control |
Relay outputs | 6-pin Euro-style (two) outbound control |
USB port | Config and management interface |
Control RJ45 | 10/100 Mbps network management |
SD card receptacle | Configuration memory card (1 GB min) |
HI and VI Impaired Outputs | |
Output stage type | Single ended (balanced Z) |
Output impedance | 50 ohms |
Nominal output level | -11.8 dBu (200 mV rms) |
Loading requirements | RMIN = 2 kΩ, CMAX = 4 nF |
Control Network | |
Protocol | Standard TCP/IP implementation over Ethernet or Fast Ethernet. |
Data rate | 10/100 Mbps |
Connection requirements | Cat-5 UTP cable or better (100 m maximum length), direct connection to wired network switch ports only, dedicated LAN or VLAN |
Line voltage requirements | 100–240 VAC, 50/60 Hz |
Dimensions (HWD) inches | 5.25 × 19 × 15.2 |
Dimensions (HWD) mm | 133 × 483 × 386 |
Weight | 16.6 lb (7.5 kg) |
Specifications are subject to change without notice